Nissan Rear Suspension Bolt Set Replacement (New)

This kit is designed to be used in conjunction with Gktech Eccentric Lockout kits.
Found here for S13/R32/C33/A31.
Found here for S14 & S15 / C34 & C35 / R33 & R34

This kit suits the following vehicles:
Nissan Silvia S13* / S14 / S15 - The bolts will protrude 5mm further on S13
Nissan Skyline R32* / R33 / R34 - The bolts will protrude 5mm further on R32
Nissan Laurel C33* / C34 / C35 - The bolts will protrude 5mm further on C33
Nissan Cefiro A31* - The bolts will protrude 5mm further on A31

*Extra protrusion is generally not an issue, however you may need to trim them back on the outer positions of the S13/R32/C33/A31 incase they foul against other components.

This hardware kit contains 12x 10.9 Grade Hexagonal Cap Screw , 6x 8.8 Grade Hexagonal Nyloc nuts, 6x Grade 8.8 Hexagonal Nuts & 6 Spring Washers
These bolts are used to replace the OEM Hardware on both sides of the vehicle in the following positions:
Rear Upper Camber Arm (Outer) (2)
Rear Upper Traction Arm (Outer) (2)
Rear Toe Arm (Outer) (2)
Rear Traction Arm (Inner) (2)
Rear Lower Control Arm (Inner) (4)

The Gktech kits replace the following:
Rear Upper Camber Arm (Inner) (2)
Rear Toe Arm (Inner) (2)

Failure to use the Gktech kits can result in more frequent wheel alignments or increased tyre wear as the OEM Eccentric bolts move around over time causing the wheel alignment to change.

This kit replaces the OEM hardware that is no longer suitable for New Zealand Roads & LVVTA Cert due to the added thickness in the material of aftermarket suspension components causing the OEM hardware to become too short as well as the remaining oem hardware in the lower control arm inner mounts and the traction arm inner mount.


When fitting this hardware kit, please make sure you fit the Rear Toe Arm (Outer) bolts facing the rear of the vehicle so it does not foul against the Shock Absorber body.